MINOLTA DI470 X64 DRIVER DOWNLOAD

Please see Bulletin for details. Would you use this site again?: Please refer to the ‘ReadMe’ file. Mode when the Pie is installed with the controller HDD. Solution For the code C check the following: Please refer to bulletin C for the current firmware. If the voltages fall in this range replace the PWB-A.

Uploader: Gardasida
Date Added: 23 June 2006
File Size: 59.19 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 85530
Price: Free* [*Free Regsitration Required]

The machine is being set up without a finisher.

Konica Minolta Di552 Di470 Ps Driver Download

This indicates insufficient memory for scanning. The selection is available under tab [5 of 6] once entering the Users Choice Mode. All programmed addresses will be cleared. News Blog Di407 Twitter Newsletter. Please help us maintain a helpfull driver collection. Copy output may have a buildup of toner along the leading edge and copies may also be output with toner blotches and speckles. Go to Function Limit.

Memory requirements are detailed in bulletin To check enter the Tech Rep. Solution The bit driver files are mnolta recognized when attempting to load on a bit system, therefore, the files must be pulled from a bit system in order to add additional driver support on a bit server: Users are responsible for seeking advice of a Konica Minolta authorized service representative regarding the information, opinion, advice or content of this document.

Recent Drivers  HP LASERJET M1522N DRIVER DOWNLOAD

If all the above fails, perhaps you could set up a virtual machine minota XP mode, install the printer driver in that VM, then share the printer out from there?

In addition, other copy quality issues may be present like poor fill and shading. Machine not going to ready state. Actually, the config fi470 that it spits out is for the x3, so it would appear I need the x3 driver.

The paper appears to be slowing down as it passes through the fuser.

SOLVED: I need the Konica Minolta Di Driver for Windows – Fixya

This will return the controller type to 0. Most coin-op devices do not provide the ability to duplex and multi-feed. This is the specification for Energy Star and this copier.

Please reset the NIC by performing the following: You could try a generic printer driver, but that way you would not be able to use all functions you are used to. Right now, I have to email myself or share documents to my laptop, then walk across the office to print from there.

Recent Drivers  LEXMARK X2500 LINUX DRIVERS FOR MAC

Go to Tech Rep Choice. The optional ECC board is used only when the machine is connected to an external controller Pi Will keep trying, though. Finally my PC got up to speed! See the switches section of the Field Service Manual for further information. Solution There is a limit, which depends on whether the machine is set to “Printer Priority” or “Copier Priority.

Having a controller attached at the time the copier is flashed may cause the copier to lock up, and give the appearance of a dead copier. Click on Job Management Tab. In addition, under tab [5 of 6] is a choice for “Energy Save”.

Check printer firmware version in Tech. Then it will be difficult. Scanning to FTP is not supported by the Pi Konica Minolta Di drivers are tiny programs that enable your Multifunction Printer hardware to communicate with your operating system software.